新闻资讯

News Center

NEWS center
News

BM series cycloidal hydraulic motor (end flow dist...

2023-07-24

BM series cycloidal hydraulic motor (end flow distribution) motor troubleshooting

The motor is a precision component that needs to be installed and repaired by professionals. Without the consent of the company, shall not be broken inspection repair. If permitted by the company and the user has the conditions for dismantling, after reading the instructions in detail, you can fold and inspect yourself, but you must pay attention to it

Here are three points:

1, do not touch the parts during decomposition, especially to protect the zero movement surface and sealing surface. In the clean sensor of the exposed piece decomposed, it is necessary to swim without hitting the stone phase. Do not use a needle hammer when disassembling and special assembly.

2. The removed parts should be carefully inspected, and the worn parts are basically not repaired by themselves and replaced. In principle, all seals should be replaced.

3. All parts should be cleaned and blown before assembly, and cotton yarn, rags and other pieces should not be used to wipe them. The assembly site and the tools used should be clean, and the output shaft should be rotated after assembly and should be flexible without stuck phenomenon